Climate

Radiation Use Efficiency

Abbreviation: RUE

Unit: g DM / MJ

The amount of dry matter produced per unit of intercepted photosynthetically active radiation — a measure of how efficiently a crop converts sunlight into biomass, typically expressed in g DM per MJ.

Radiation use efficiency (RUE) links light interception to biomass accumulation and ultimately yield. Yield = intercepted radiation × RUE × harvest index. Typical RUE values: wheat 1.4–1.8 g/MJ, maize 1.5–2.0 g/MJ, potato 1.5–1.8 g/MJ, cover crops 1.0–1.4 g/MJ. RUE is reduced by nutrient stress (especially N and S), disease (flag leaf destruction), drought, temperature extremes and lodging. Genetic improvement has largely been achieved through raising harvest index rather than RUE — RUE is thought to be close to its theoretical maximum in well-managed crops. Increasing light interception (rapid canopy closure, optimum plant population) and protecting the canopy through the grain-fill period are the practical levers agronomists use.

Radiation use efficiency by crop

CropRUEIntercepted PARTypical yieldHINotes
Winter wheat 1.4–1.8 g DM/MJ 1,200–1,600 MJ/m² 8–11 t/ha grain 0.45–0.55 RUE sensitive to N, septoria and lodging; peaks at flag leaf stage
Maize (grain) 1.6–2.0 g DM/MJ 800–1,200 MJ/m² 9–13 t/ha grain 0.40–0.55 High RUE in warm seasons; sensitive to cold early establishment and waterlogging
Potato 1.2–1.6 g DM/MJ 700–1,100 MJ/m² 40–60 t/ha tuber 0.65–0.80 High HI compensates for moderate RUE; radiation interception limited by canopy duration
Cover crop (mixed) 0.8–1.2 g DM/MJ 300–700 MJ/m² 1–4 t/ha DM N/A Lower RUE expected; value in radiation interception to prevent soil erosion and nitrate leaching

The RUE yield equation

Biomass production and final grain yield can be understood through a simple multiplicative framework: Grain yield = Intercepted PAR × RUE × Harvest Index. Intercepted PAR is the total photosynthetically active radiation (wavelengths 400–700 nm) captured by the crop canopy over the season — typically measured in MJ/m² or MJ/ha. RUE converts that intercepted radiation into total above-ground dry matter. Harvest Index (HI) then partitions that dry matter into the harvested product (grain, tuber, root).

Improving yield therefore requires improvements in one or more of these three components. Agronomic practices that extend canopy duration (e.g., disease control to protect green leaf area), increase canopy density (population, row spacing optimisation) or improve partitioning efficiency (PGR use, nitrogen management through grain fill) all operate through this framework. See the harvest index entry, growing degree days entry and leaf area index entry for the related concepts in crop development models.

RUE, nitrogen and disease: the practical connection

Nitrogen is the agronomic factor most closely linked to RUE in arable crops — N is required to build chlorophyll and Rubisco (ribulose-1,5-bisphosphate carboxylase/oxygenase), the enzyme that catalyses CO₂ fixation. A wheat plant with inadequate N has fewer functional photosynthetic units per unit leaf area, and its RUE falls accordingly. Similarly, foliar diseases such as septoria tritici blotch, yellow rust and mildew directly reduce the photosynthetic efficiency of affected leaf tissue — even before the leaf senesces, infected tissue has reduced chlorophyll content and impaired CO₂ fixation. Protecting green leaf area duration (GLAD) through a well-timed fungicide programme is therefore protecting both interception (keeping the canopy alive and active) and RUE (keeping the functioning tissue efficient). The wheat nutrition management guide and the precision nitrogen management guide both address how N programme design links to maintaining canopy photosynthetic efficiency throughout grain fill.

Frequently asked questions

How is radiation use efficiency used to estimate crop yield?
The fundamental yield equation links RUE to final grain yield via three components: Grain yield = Total intercepted PAR × RUE × Harvest Index. For a UK winter wheat crop: intercepted PAR ≈ 1,400 MJ/m² over the season (around 50–55% of total incoming PAR), RUE ≈ 1.5 g DM/MJ, HI ≈ 0.50. This gives total above-ground DM ≈ 21,000 kg/ha (21 t/ha), with grain yield ≈ 10.5 t/ha. Crop models such as SIRIUS, DSSAT and APSIM use this framework as a core prediction engine, modified by daily temperature, water stress and N stress. Understanding this equation helps explain why yield gaps exist: a 20% reduction in canopy interception (through poor establishment or disease) or a 15% reduction in RUE (through N deficiency or lodging) each reduce yield roughly proportionally. See the harvest index entry and the growing degree days entry for the related concepts used alongside RUE in crop models.
What factors reduce radiation use efficiency below its potential?
Several agronomic and environmental factors reduce RUE below its potential value: (1) Nitrogen deficiency — N is a structural component of chlorophyll and Rubisco; deficient crops have less photosynthetic machinery per unit leaf area, directly reducing RUE; a 20–30% reduction in RUE has been measured in severely N-deficient wheat. (2) Foliar disease — septoria tritici blotch, rust and mildew destroy functional green leaf area and reduce photosynthetic efficiency in surviving tissue; a severe untreated septoria epidemic can reduce wheat RUE by 15–25%. (3) Water stress — stomatal closure under drought reduces CO₂ entry to leaves, reducing photosynthesis per unit intercepted radiation. (4) Lodging — fallen crops experience mutual shading; the effective canopy architecture deteriorates and PAR distribution is uneven, reducing RUE. (5) Waterlogging — root oxygen stress disrupts nutrient uptake, reducing photosynthetic capacity indirectly. (6) Temperature extremes — enzyme kinetics are outside optimum; RUE falls in hot, cold or frost-affected periods. See the wheat nutrition management guide and precision nitrogen management guide for N-related RUE management.
How does radiation interception differ from radiation use efficiency?
These are two separate and multiplicative components of biomass production that are often confused: Radiation interception (measured as a fraction, 0–1, or as a percentage) describes how much of the incoming photosynthetically active radiation (PAR) is actually absorbed by the crop canopy — determined by canopy size, leaf angle, leaf area index (LAI), and canopy duration. A crop canopy with LAI >3.5 typically intercepts 85–95% of incident PAR. Radiation use efficiency (g DM / MJ intercepted PAR) describes how efficiently the intercepted radiation is converted into dry matter — determined by photosynthetic capacity, CO₂ supply, N status and species-level characteristics. Yield improvement strategies must target both: increasing radiation interception (earlier canopy closure, optimising plant population, protecting green area duration) and maintaining RUE (N management, disease control, avoiding lodging). It is possible to have high interception and low RUE (diseased crop with large but poorly functioning canopy) or high RUE but low total yield due to short canopy duration (early-maturing variety with limited interception period). See the leaf area index entry for the canopy interception context.
Why does maize tend to have a higher RUE than wheat in warm summers?
Maize is a C₄ photosynthesis crop; wheat is a C₃ crop. C₄ plants use a biochemical CO₂-concentrating mechanism (the C₄ cycle, operating in mesophyll cells, which pre-concentrates CO₂ into bundle sheath cells where Rubisco operates) that nearly eliminates photorespiration — the wasteful process in C₃ plants where Rubisco mistakenly fixes O₂ instead of CO₂, consuming energy without producing sugar. In warm, bright conditions (typical UK maize growing season, June–August), photorespiration in wheat consumes 20–40% of gross photosynthate — maize avoids almost all of this loss. The result is that maize RUE typically reaches 1.6–2.0 g DM/MJ compared with wheat's 1.4–1.8 g DM/MJ under good conditions. However, maize's C₄ advantage is temperature-dependent — below 15°C, the C₄ enzymes work less efficiently, and in the cool UK spring maize can actually photosynthesise less efficiently than wheat. This is one reason maize requires a long establishment period and a warm, well-drained seedbed to achieve its high yield potential. See the growing degree days entry for the thermal requirements of maize development.
How can agronomists use RUE concepts practically in the field?
While RUE is measured in research rather than farm practice, the concept informs several practical management decisions: (1) Nitrogen timing to protect RUE — maintaining leaf N status throughout grain fill keeps Rubisco levels high in the flag leaf, sustaining RUE; the precision N management approach of in-season sensing responds to actual N status and prevents the RUE decline from N deficiency. (2) Green leaf area duration (GLAD) — fungicide programmes protecting against septoria and rust are fundamentally protecting green leaf area × duration (which drives both interception and RUE); economic GLAD models estimate the yield value of protecting each unit of green leaf area. (3) PGR application to prevent lodging — lodging collapses canopy architecture and simultaneously reduces radiation interception and RUE; PGR timing (T1 for stem base) prevents the most damaging lodging episodes. (4) Variety choice — varieties with higher intrinsic RUE (assessed in AHDB variety trials via biomass production data) maintain yield potential under stress. (5) Cover crop management — after the cash crop, maximising radiation interception by a cover crop canopy prevents energy "wasting" to bare soil heating and supports the soil carbon input value of cover crops. See the precision N management guide and cover crop mixtures guide for applied guidance on each.