Nutrition

Iron Deficiency

A nutritional disorder caused by insufficient iron availability to the plant, characterised by interveinal chlorosis in young leaves — most common on high-pH, calcareous or waterlogged soils.

Iron (Fe) is an essential micronutrient required for chlorophyll synthesis, enzyme activity and electron transport. Although Fe is abundant in most soils, it becomes almost insoluble at pH above 7 and unavailable under anaerobic conditions. Interveinal chlorosis appears first on the youngest leaves — unlike magnesium deficiency which appears on older leaves — because Fe is immobile in the phloem. High-pH soils (pH > 7.5), calcareous soils and waterlogged soils are highest risk. Correction is difficult: foliar Fe sprays give short-term response; acidifying the soil with sulphur in the longer term, improving drainage and selecting tolerant varieties or rootstocks are more sustainable solutions. Fe chelate drenches or fertigation work in horticultural and high-value crops.

Iron deficiency by soil type: risk and management

Soil / SituationSymptomsRiskManagementNote
Calcareous/chalk soils Interveinal chlorosis on young leaves; veins remain green High (pH >7.5) Foliar Fe chelate; soil acidification long-term; drainage improvement Young leaves affected first — Fe is immobile in phloem
Waterlogged soils Paradoxically: Fe toxicity in reducing conditions; deficiency in drainage channels Variable by drainage Improve field drainage; avoid compaction Waterlogging can cause both Fe deficiency (in oxidised zones) and Fe toxicity (in reduced zones)
Sandy soils pH >6.5 Pale yellow-green new leaves; older leaves normal Medium (recent liming) Avoid over-liming; foliar spray Risk increases rapidly after pH correction above 7.0
High-phosphate soils Fe deficiency can be induced by excess P application Low–medium Reduce excess P inputs; balance P:Fe ratio Excess P competes with Fe in soil and within plant

The pH-iron availability relationship

Iron deficiency is fundamentally a soil chemistry problem driven by pH. Total iron content is rarely limiting in UK soils — typical concentrations are 10,000–50,000 mg/kg. However, plant-available iron (Fe²⁺, Fe³⁺ chelates in the soil solution) falls to near-zero at pH above 7.5. This means that iron deficiency in UK arable crops is almost always associated with high-pH calcareous or chalk soils, or soils that have been over-limed above the crop target pH. The agronomic response is either foliar correction or, for the long term, careful pH management to avoid exceeding target pH. See the liming and soil pH management guide for the target pH framework.

Diagnosing iron deficiency vs other chlorosis causes

Correct diagnosis of iron deficiency requires distinguishing it from: magnesium deficiency (older leaves chlorotic, not youngest); manganese deficiency (similar to Fe deficiency on younger leaves but typically in grey-green streaks rather than interveinal chlorosis); virus symptoms (BYDV in cereals — yellow leaf discolouration usually involves leaf reddening not interveinal yellowing); and sulphur deficiency (uniform yellowing, starts on youngest leaves as with Fe, but rarely as intense as Fe chlorosis). Tissue testing provides definitive confirmation. See the sulphur glossary entry and the magnesium glossary entry for comparison symptom detail.

Frequently asked questions

Which crops are most susceptible to iron deficiency in UK conditions?
In UK arable systems, the crops most susceptible to iron deficiency are those grown on high-pH or calcareous soils: maize (pH >7.0 frequently causes visible interveinal chlorosis, particularly in cool springs when roots are less active); sorghum where grown; soybean in trial plots; and some horticultural crops including raspberries, blueberries and other ericaceous plants grown on naturally neutral or alkaline soils. In UK cereal crops (wheat, barley), iron deficiency is rare because these monocots are more efficient at acquiring Fe from high-pH soils through the secretion of phytosiderophores (chelating agents from roots). Oilseed rape and legumes are intermediate in susceptibility. The crop most commonly showing Fe deficiency symptoms in UK arable contexts is maize — particularly in cold, wet springs on pH 7.0+ soils. See the maize nutrition management guide for the management context.
How does soil pH affect iron availability and why does over-liming cause deficiency?
Iron solubility decreases by 1,000-fold for each unit increase in soil pH above pH 6. At pH 7.5, iron solubility in the soil solution is so low that most crops cannot take up sufficient Fe through mass flow alone. The primary mechanism of Fe acquisition in dicot plants is through the reduction of Fe³⁺ to Fe²⁺ at the root surface (Strategy I plants) — this process is less effective at high pH. Over-liming — applying too much lime and raising pH above the crop target — can induce Fe deficiency even on soils with adequate total iron content. This is why potatoes, which prefer pH 5.5–6.0, are particularly at risk if a rotation field is over-limed before the potato phase. See the liming and soil pH management guide for pH target management and the soil pH glossary entry for the nutrient-pH interaction chart.
What is the difference between iron deficiency and magnesium deficiency symptoms?
Both iron and magnesium deficiencies cause leaf yellowing (chlorosis), but the pattern is different and distinguishing them is important for correct diagnosis: Iron deficiency: interveinal chlorosis on youngest (newest) leaves — veins remain green while interveinal tissue turns yellow-green to bright yellow. Fe is immobile in the phloem, so it cannot be remobilised from older to newer leaves. Magnesium deficiency: interveinal chlorosis on older (lower) leaves — same interveinal yellowing pattern but progressing upward as Mg is remobilised from old to new growth (Mg is phloem-mobile). In practice: if the tops of the plant look yellow and the base looks normal, think iron; if the base looks yellow and the top is green, think magnesium. Both can occur on the same field in different zones depending on pH and soil variability. See the magnesium glossary entry for Mg deficiency symptom detail.
How can iron deficiency be corrected in the growing season?
Correcting iron deficiency once symptoms appear is challenging because soil applications are largely ineffective — iron applied to soil rapidly becomes insoluble at high pH. The practical correction options are: (1) Foliar Fe chelate sprays — Fe EDTA or Fe DTPA chelates applied as a foliar spray at 300–500 g Fe/ha in 200 L water; repeated applications may be needed as the effect is temporary and new growth remains susceptible; (2) Fe chelate drenches or fertigation — for horticultural crops under irrigation, Fe chelate (Fe EDDHA is most stable at high pH) can be applied through the irrigation system to the root zone; (3) Soil acidification — elemental sulphur applied to the soil surface around the affected plants can lower local pH over time, but is a long-term intervention rather than an immediate fix. For UK arable crops (primarily maize on calcareous soils), foliar Fe chelate sprays at the first sign of yellowing at GS12–13 are the standard response. There is currently no approved seed treatment that provides lasting Fe protection in high-pH soils.
Can waterlogging cause both iron deficiency and iron toxicity simultaneously?
Yes — this apparent paradox reflects the different chemistry in waterlogged vs oxic soil zones. In waterlogged (anaerobic) conditions, Fe³⁺ is reduced to Fe²⁺ (ferrous iron) by soil microbes — Fe²⁺ is much more soluble and can accumulate to toxic levels (iron toxicity symptoms: reddish-brown leaf tips, rust-coloured lesions, root damage). This is most commonly a problem in paddy rice cultivation but can affect UK crops in severely waterlogged conditions. In the oxic zones at the boundary of waterlogged areas (e.g., drainage channels), Fe²⁺ is rapidly oxidised to Fe³⁺ as it reaches oxygenated conditions, precipitating as Fe(OH)₃ and reducing availability sharply. The practical management response is the same in both cases: improve field drainage to maintain predominantly oxic conditions. See the available water capacity glossary entry for drainage context.